First: remove the wet curtain (a total of four parts, not points in turn.)

1. First twist the three screws on the upper end of the wet curtain.

2. Hold the shutter at the upper end of the wet curtain, pull the wet curtain out gently and then lift it up slightly to remove the wet curtain.

Second: remove the machine cover and water mains.

1, first twist the screw on the machine cover, and then lift the machine cover up.

2. Loosen the hose collar on the water supply pipe and loosen the water supply pipe. Lift up the total distribution pipe and get it.

Third: cloth water pipe cleaning.

1, if the hole on the water pipe is blocked, you can use the steel wire to poke empty.

2. Clean the stains on the cloth pipes with cold water.

Fourth: car chassis and spare parts cleaning.

1, clean the car chassis: you can use a soft cloth or brush to clean the car chassis.

2, clean the fan blade: you can use a soft cloth to wipe the fan blade. Be careful not to drop dust from the blades into the ducts.

3, clean the water level sensor: you can use a small wet rag to clean the water level.

4, cleaning the centrifugal pump: can use the brush to clean the centrifugal pump and the dirt on the filter net.

5, clean the laundry drain valve: pay attention to the stain at the bottom of the drain valve.

Fifth: wet curtain cleaning.

1, clean the wet curtain from inside to outside with cold water (note: the pressure can not be too high when cleaning, prohibit the use of acid alkaline or alkaline detergent to clean the wet curtain.

2. Filter: filter can be removed and cleaned once a week. (only limited to its filter model).

Sixth: filtering device cleaning. The cleaning method is as follows:

1. Twist down the back cover of the filter device:

2. Eliminate the dirt on the filter element: install the rear cover plate again.

Seventh: after cleaning, according to the reverse order of the specific steps to remove the naked machine. Warning: Shut down and turn off the switching power supply when cleaning the generator set otherwise there may be leakage risk or other damage to the body of the generator set.