Nowadays, industrial air coolers have been common in every work, and when the application time arrives, there will be all kinds of minor faults. In fact, we can deal with them by paying attention to them and sorting them out on time when we use them. Here is the following I industry air cooler application notice!

Matters needing attention

Because the living environment of industrial air coolers is more complex (most often industrial plants), it is necessary to carry out maintenance to it to avoid some emergencies that cause damage to the quality of centrifugal fans and harm the operation. Maintenance of a little more, summarized as follows:

1, each wet curtain machine is suitable for 70-100 square meters of room temperature reduction. More than this standard value, it is likely that the actual effect will not be particularly ideal, and easy to cause equipment fatigue and problems.

2, when the air cooler is used, it is necessary to check whether there are any impurities such as shredded paper and dust in the wet curtain and reservoir. It should be cleaned up 1 or 2 times in the service life of the air conditioner every year. The water in the pool should be drinking water or other clean water.

3. The centrifugal fan is the heart of the air cooler. If there is a fault, the power supply should be turned off immediately and the electrician should be asked to repair it immediately. When assembling, attention should be paid to connecting the ground wire and disassembling the centrifugal impeller should be centered to prevent the leaf deformation from colliding with the shell.

4. If the air cooler float switch fails to operate and there is less water in the pool or overflow water seepage, it should be corrected and replaced in time.

5, if it is found that the wet curtain power supply is not enough or uneven, it is necessary to check whether the water storage tank is dry, whether the pump is running and the water supply pipe road and the water pump into the water part of the spray pipe road is blocked, and check whether the spray pipe road is located in the middle of the wet curtain. The normal relative height of sprinkling water can not be ignored, if the water level is too low, it may burn the machine.

6. When the air cooler is being repaired, the power should be cut off. After a period of time after the power is turned off, the static electricity will be released due to long-term use.

The above is the introduction of industrial air cooler application precautions, hope to be able to have some help.