First: remove the wet curtain

1. Unscrew the three screws on the upper part of the wet curtain.

2. Hold the blinds on the upper part of the wet curtain, pull the wet curtain out gently and lift the wet curtain slightly to remove it.

Second: remove top cover and water pipe assembly.

1, first unscrew the screw on the top cover, and then lift the top cover.

2. Loosen the hose hoop on the water pipe and loosen the water pipe, lift the water pipe assembly and take it down.

Third: cloth water pipe cleaning.

1, if the hole on the water pipe is blocked, you can use the wire to poke it empty.

2. Clean the stains on the water pipes with clean water.

Fourth: chassis and accessories cleaning.

1. Clean the chassis: use a soft cloth or brush to clean the chassis.

2, cleaning blades: use soft cloth to wipe the blades. Be careful not to drop dust from the blades into the duct.

3, cleaning water level sensor: can use a small wet cloth on the water level of the dirt wash away.

4, cleaning the water pump: the water pump and the dirt on the filter net can be washed clean with a brush.

5, clean the laundry drainage valve: pay attention to the dirt at the bottom of the drainage valve.

Fifth: wet curtain cleaning.

1. Wash the wet curtain from inside to outside with clean water (note: the water pressure can not be too high when cleaning, and it is forbidden to use acid or alkaline detergent to clean the wet curtain.

2. Filter: filter can be removed and cleaned once a week. (only for models with filters).

Sixth: filter cleaning. Cleaning methods are as follows:

1. Twist the back cover of the filter down:

2, clean the dirt on the filter element: put it back on the back cover.

Seventh: after cleaning, reinstall the machine in reverse order according to the steps of disassembly. Warning: the unit must be shut down and power off when cleaning, otherwise electric shock or other damage to human body will occur.