One of the important website products and key keywords of chillers should be treated seriously in their learning attitudes. In terms of learning requirements, it is necessary to achieve this level so that they can be used correctly and reasonably. Cooling fans, and at the same time, to get good results. Therefore, based on this, the next step will be to explain the knowledge in this area so that everyone can master and apply it in time.

1. The chiller in the cold storage, if it is frosted, is it necessary to carry out defrosting work?

If the chiller in the cold storage has frost formation, then it is necessary to perform defrosting work. Otherwise, the chiller cannot work normally. Moreover, in the defrosting method, it can be either a manual defrosting or a mechanical defrosting. As for which one to use, it depends on the actual situation, and it is determined by it.

2. Air coolers, how can they be classified in a big way?

In terms of the large aspect, the air cooler can be divided into two types: a domestic air cooler and an industrial air cooler. If it is a domestic air cooler, it is mainly used to reduce the indoor temperature in summer, and industrial cooling fans, which are generally used in refrigeration equipment, are an important part of the refrigeration equipment. For example, it can be used as a cold storage machine. .

3. The over-flow protection of the air cooler, how should it be handled?

The over-current protection of the air cooler is a protection mechanism of the air cooler, indicating that the current in the equipment exceeds the specified limit, and the equipment has a fault problem. At this time, the operation of the air cooler should be stopped immediately. Check the work to identify the problem and resolve it in time to avoid adverse effects or consequences.

All of the above problems are related to the air cooler, and at the same time, it is also related to the website products. Therefore, I hope that everyone can take it seriously and carry it out so that it can be mastered in time. In this way, it can be applied to the actual work, and at the same time, to improve the use of the product, so that you can benefit from it.