First: remove the wet curtain (a total of four parts, no particular order.)

1. Unscrew the three screws on the top of the wet curtain directly.

2. Hold the shutter on the top of the wet curtain, pull the wet curtain outward gently and lift it up slightly to remove the wet curtain.

Second: remove the cover of the machine and the general process of the water pipe.

1. Unscrew the screw in the cover directly, and then lift the cover up to get it.

2. Loosen the throat collar in the water supply pipe and loosen the water supply pipe, and lift the water distribution pipe up and take it.

Third: the cleaning of the water pipe.

1. If the hole in the water pipe is blocked, it can be poked empty with fine wire.

2. Clean the stains in the water pipe with warm water.

Fourth: car chassis and accessories cleaning.

1, cleaning the car chassis: you can use a soft cloth or brush to clean the car chassis.

2, clean the fan blade: you can wipe the fan blade with a soft cloth. Remember not to drop the dust in the fan blades into the air duct.

3. Clean the water level sensor: you can use a small wet rag to clean and wash the dirt in the water level line.

4, cleaning centrifugal water pump: you can use a brush to clean the centrifugal water pump and the dirt in the filter.

5. Clean the laundry discharge valve: pay attention to the stains at the bottom of the discharge valve.

Fifth: wet curtain cleaning.

1. Clean the wet curtain with warm water from inside to outside (note: the pressure can not be too high when cleaning, and it is forbidden to use acid-alkaline or alkali detergent to clean the wet curtain.

2, filter screen: filter screen can be removed once a week to clean. (only with filter model).

Sixth: Filter cleaning. The cleaning method is as follows:

1. Twist off the back cover of the filter device:

2. Eliminate the dirt in the filter element: install the back cover plate.

Seventh: after the completion of cleaning, install the whole equipment back in the reverse order of the removed process. (Warning: when cleaning the generator set, it is necessary to shut down and unplug the power supply, otherwise it will produce the danger of electric shock or other damage to the body of the generator set.